
Originally Posted by
stoker
I plugged in everything in beautifully, except, the cable is white, and I could not figure out how to run the cable from the trunk through to the front, by hiding it along the prewired corridors. I have no idea whether I can poke this white cable along the route where I see the 13pin cable is going to the front. It is too dark, and am afraid if I push this cable through , I might lose it in the prewired network heading out from the side of the inside of the car. Right now I have this white cable looking awful, because I lifted the left rear drivers side seat, and it comes through the bottom of the seat, along the floor to below the right drivers armrest. It looks terrible. I need to have it looking professional. Anyone that might know how to get this cable to install neatly so it is not visible, would be much appreciated