2005 silverado remote start

[t.gregory]

bought the ads-pl datalink solo series ans a hornet 570t remote start need wiring for datalink and any help would be greatful
Thanks

[autotoys]

What exactly do you need help with?

Tech sheet below



Chevrolet 2005 Silverado 2DR Pickup
(Remote Start / Security / GPS)


Remote Start / Security / GPS
Wire/Function Colour Location/Description Polarity
PASSIVE ANTI-THEFT YES PASSLOCK 2 SEE NOTES
12 VOLTS Red Ignition switch harness +
IGNITION Pink Ignition switch harness +
IGNITION 2 White Ignition switch harness +
These wire are smaller the other wires from the ignition switch. Test carefully.

ACCESSORY Orange Ignition switch harness +
STARTER Yellow Ignition switch harness +
These wire are smaller the other wires from the ignition switch. Test carefully.

KEY SENSE Lt.green At steering column -
TACH SIGNAL SEE NOTES
There is a coil for each cylinder, each with a 4-pin plug. Each plug contains a BLACK, BROWN & PINK, as well as a 4th wire which changes color on each coil. This 4th wire can be used as your tach reference, set your remote starter for a 1 cylinder signal.

DIESEL TACH SIGNAL White Pin-A2 behind instrument cluster AC
FUEL INJECTOR Opposite of Pink wire At any injector on engine AC
LOCK SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.

UNLOCK SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.

ARM SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.

DISARM Lt.green At driver's door module -
Part of switch assembly inside driver's door.

GLO-PLUG SIGNAL Dk.blue Behind instrument cluster -
DOMELIGHT / ALL DOORS Gray/black At courtesy light under dash +
BRAKE SWITCH White At switch above brake pedal +
PARKING LIGHTS Gray/black At light switch harness -
PARKING BRAKE Lt.blue At switch on handbrake lever -
HORN Black At steering column -
VSS WIRE Green/black At PCM left front of engine compt. AC
DATABUS INTERFACE Pin-2(top row from left) Diagnostic plug below dash DATA
PASSLOCK DATA Yellow In 3 wire harness from ignition switch DATA
PASSLOCK GROUND Black or Orange/black In 3 wire harness from ignition switch -



Available Notes
Vehicle Notes
PLEASE NOTE: This vehicle is equipped with GM's PASSLOCK 2 passive anti-theft system. Please refer to the appropriate diagram before any remote start installation.

Additional Notes
N/A
Personal Notes
N/A


Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. Autoland and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and Autoland and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in any other way. The information supplied is a guide only.

[t.gregory]

i have remote start wired up i also have the datalink bypass my alarm does not have a data port i need to use standard wiring from the bypass to remote start on datalink i take orange=data to pin 2 on the obdii
my ? is the pink wire from the datalink says ignition input what type of input from ignition. Also on standard wire hookup the red 12 volt to remote start box. does that mean that remote box gives 12volt when remote is activated.
the black from datalink to remote box. does that mean remote box gives me a ground or chassis ground. And blue/white at remote box is ground out when running does that mean the remote box grounds out when running
Any help will be great


Thank You

[autotoys]

i have remote start wired up i also have the datalink bypass my alarm does not have a data port i need to use standard wiring from the bypass to remote start on datalink i take orange=data to pin 2 on the obdii
my ? is the pink wire from the datalink says ignition input what type of input from ignition.

*** Hi, this wire goes to an wire for the ignition (when ignition is 12 volts)


Also on standard wire hookup the red 12 volt to remote start box. does that mean that remote box gives 12volt when remote is activated.

**** 12 volt CONSTANT power ** FUSED, INPUT. Not an output


the black from datalink to remote box. does that mean remote box gives me a ground or chassis ground.

** this needs to hook up to a GROUND, not an output


And blue/white at remote box is ground out when running does that mean the remote box grounds out when running

Yes, this wires to the GROUND while running output (-) of your alarm. If you are DEI, it is usually the SMALL blue wire or small blue/white wire.



Thank You

[autotoys]

For people looking for a great GM bypass, you can see the ADS ADS TB PL gm bypass

CLICK HERE FOR ADS TB PL BYPASS