STARTNR2 and Parking Light Question

[ragj1976]

Hi, I am looking over the manual for the STARTNR2. I am planning on putting this in a 2008 Honda Ridgeline. Can someone clarifiy for me the parking light wires see a cut from the manual here :

H2-2 RED (FUSED): PARKING LIGHT INPUT:
- This input will be determined depending on the type of parking light circuit a particular vehicle has (positive or
negative trigger). If the vehicle has positive triggered parking lights, connect this input directly to (+)12v. If the
vehicle has negative parking lights, send this input to (-) ground.
H2-3 WHITE: PARKING LIGHT OUTPUT:
- THIS IS A VITAL CONNECTION AS THE VEHICLE’S PARKING LIGHTS WILL CONFIRM REMOTE ENGINE START
- Connect this wire to the vehicle’s (+)12v parking light circuit.
- This output will provide a flashing (+)12v signal to energize the vehicle’s parking lights.
- The vehicle’s parking light wire will show (+)12v only when the light switch Is turned to the PARKING LIGHT and
HEAD LIGHT positions.
- The vehicle’s parking light wire can usually be found at the light switch, fuse junction block, or in the harness
which runs to the rear of the vehicle (usually found in the driver’s side kick-panel).
- For vehicles with separately fused LEFT and RIGHT side parking light circuits, either 2 diodes (6-10 amps each)
or 2 external relays can be used to separate t


The H2-2 Parking Light input, can that be an Accessory input? Or does it have to be a constant 12V? I am confused on that.

Thanks
-Roger

[autotoys]

Remote Start/Security

Function Equipped Type iC
PASSIVE ANTI-THEFT YES TRANSPONDER SEE NOTES



Wire/Function Colour Location/Description Polarity
iC


12 VOLTS White Ignition harness +



IGNITION Black/yellow Ignition harness +



ACCESSORY Yellow Ignition harness +



ACCESSORY 2 * White/Black ignition switch harness +


notes * not necasary for remote start and climate controls

STARTER Black/white Ignition harness +



KEY SENSE Red/white Ignition harness -



TACH SIGNAL Blue At any of the coils on the engine AC



FUEL INJECTOR * N/A opposite black white at inector AC


LOCK Pink/black On left side of fusebox above driver's kick -



UNLOCK Pink/blue On left side of fusebox above driver's kick -



ARM White/red In driver's door on switch assembly -



DISARM White In driver's door on switch assembly -



DOMELIGHT / ALL DOORS Blue/red interior light switch -



Independent doorpin wires are located in the driver's kickpanel. Green (left/front), Green/red (right/front), Green/yellow (left/rear) and Green/white (right/rear). All 4 are (-) trigger. See the available picture for exact location.
DRIVER DOOR * Green driver running board -


PASSENGER DOOR * Light Green/Red driver running board -


REAR DRIVER DOOR * Green/Yellow drver running board -


REAR PASSENGER DOOR * Green/White driver running board -


TRUNK PIN Blue/orange On back of fusebox above driver's kick -



TRUNK RELEASE * Red/Blue green connector on left side of fusebox -


BRAKE SWITCH White/black At switch above brake pedal on DKP +



PARKING LIGHTS Red/black In fusebox or DKP +



PARKING LIGHTS (-) * Blue light switch harness -


PARKING BRAKE Green/orange At switch on handbrake lever -



HORN Green/yellow At steering column -



HEADLIGHTS * Blue/Red light switch harness -


REVERSE LIGHTS Green Fusebox above driver's kickpanel +



VSS WIRE Blue/white At PCM, under hood-behind headlight AC



TRANSPONDER 12 VOLTS * White/Red transponder wiring harness +


TRANSPONDER IGNITION * Green/Black transponder wiring harness +


TRANSPONDER DATA * Red/Blue transponder wiring harness Data


TRANSPONDER DATA 1 Red/Blue Pin-2 at 7-Pin connector DATA



TRANSPONDER GROUND Brown/Yellow Pin-1 at 7-Pin connector -



SECURITY LIGHT/LED * Blue/Orange transponder wiring harness Open


DATABUS INTERFACE * Brown/Black 21 pin green connector at fuse box Data


notes * single wire databus

CANBUS SW * Brown/Black 21 pin green connector at fuse box Data


notes * single wire data bus

OEM STARTER ANTI-GRIND * Black/White Not equipped must Open starter wire +


notes * must open stater wire during remote start cycle for anti grind



* iC info NOTES
PLEASE NOTE: This vehicle may be equipped with a IMMOBILIZER passive anti-theft system ( will have GRAY ignition keys). A vehicle specific tranponder bypass module may be available for this vehicle, contact your supplier to find out.If one is not available, please refer to the appropriate security diagram before any remote start installation.
PERSONAL NOTES
Edit



Speakers
Location Size Depth
Front Doors 5 1/4 ''
Rear Side Panels 6 1/2 ''
All systems
Radio Harness
Wire Function Colour Notes Fuse # Size Location
+12V DC Battery(Constant) White 5 10 amp Fuse box at left kick panel
Switched Accessory Yellow/red 32 7.5 amp Fuse box at left kick panel
Power Antenna Black
Illumination Red/black (+) Red (-)
Factory Alarm Disarm White
Parking Brake Green/orange
Reverse Lights Green
Steering Wheel Control Wire Green/red Brown for ground; gray to navigation unit (if equipped)
VSS Wire Blue/white
Left Front + Light green
Left Front - Purple
Right Front + Blue
Right Front - Red
Left Rear + Brown/white
Left Rear - Red/yellow
Right Rear + Red/blue
Right Rear - Yellow
Subwoofer + Lt.green/red
Subwoofer - Yellow/black
At Speakers
Wire Function Colour Notes Fuse # Size Location
Left Front Tweeter + Light green If equipped with tweeters
Left Front Tweeter - Purple
Right Front Tweeter + Blue If equipped
Right Front Tweeter - Red
Subwoofer 1 + Black
Subwoofer 1 - Black/white

NOTES
Connections from XM receiver, XM satellite radio or MP3 player (if equipped) go to section B of audio unit pinout. If equipped with XM RECEIVER (located behind right side of rear seat), it has (white/red) B+ at pins 1 & 7 with fuse no. 7 of 7.5 amperes in fuse box at left kick panel. The XM receiver audio lines are red (L+), green (L-), white (R+), and black (R-). The XM SATELLITE RADIO, however is shown to have B+ power lines identical to those of the MP3 PLAYER: light blue at pin 1 & pink at pin 7, connecting to pins 1 & 7 of audio unit in section "B".
NAVIGATION UNIT (located under driver's seat) and navigation display unit have white/red B+ with fuse no. 7 of 7.5 amperes in fuse box at left kick panel, and yellow/red Accessory power (as for main radio).
DVD PLAYER UNIT power lines are the same as for the main radio unit. The VIDEO MONITOR CONSOLE is powered thru a white/blue wire & shares the ceiling light fuse, no. 6 of 10 amperes in the fuse box at left kick panel.
PERSONAL NOTES

[autotoys]

Hi, I am looking over the manual for the STARTNR2. I am planning on putting this in a 2008 Honda Ridgeline. Can someone clarifiy for me the parking light wires see a cut from the manual here :

H2-2 RED (FUSED): PARKING LIGHT INPUT:
- This input will be determined depending on the type of parking light circuit a particular vehicle has (positive or
negative trigger). If the vehicle has positive triggered parking lights, connect this input directly to (+)12v. If the
vehicle has negative parking lights, send this input to (-) ground.
H2-3 WHITE: PARKING LIGHT OUTPUT:
- THIS IS A VITAL CONNECTION AS THE VEHICLE’S PARKING LIGHTS WILL CONFIRM REMOTE ENGINE START
- Connect this wire to the vehicle’s (+)12v parking light circuit.
- This output will provide a flashing (+)12v signal to energize the vehicle’s parking lights.
- The vehicle’s parking light wire will show (+)12v only when the light switch Is turned to the PARKING LIGHT and
HEAD LIGHT positions.
- The vehicle’s parking light wire can usually be found at the light switch, fuse junction block, or in the harness
which runs to the rear of the vehicle (usually found in the driver’s side kick-panel).
- For vehicles with separately fused LEFT and RIGHT side parking light circuits, either 2 diodes (6-10 amps each)
or 2 external relays can be used to separate t


The H2-2 Parking Light input, can that be an Accessory input? Or does it have to be a constant 12V? I am confused on that.

Thanks
-Roger

http://www.autotoys.com/pics/ridgelinealarm.jpg

[autotoys]

[autotoys]

Hi, I am looking over the manual for the STARTNR2. I am planning on putting this in a 2008 Honda Ridgeline. Can someone clarifiy for me the parking light wires see a cut from the manual here :

H2-2 RED (FUSED): PARKING LIGHT INPUT:
- This input will be determined depending on the type of parking light circuit a particular vehicle has (positive or
negative trigger). If the vehicle has positive triggered parking lights, connect this input directly to (+)12v. If the
vehicle has negative parking lights, send this input to (-) ground.
H2-3 WHITE: PARKING LIGHT OUTPUT:
- THIS IS A VITAL CONNECTION AS THE VEHICLE’S PARKING LIGHTS WILL CONFIRM REMOTE ENGINE START
- Connect this wire to the vehicle’s (+)12v parking light circuit.
- This output will provide a flashing (+)12v signal to energize the vehicle’s parking lights.
- The vehicle’s parking light wire will show (+)12v only when the light switch Is turned to the PARKING LIGHT and
HEAD LIGHT positions.
- The vehicle’s parking light wire can usually be found at the light switch, fuse junction block, or in the harness
which runs to the rear of the vehicle (usually found in the driver’s side kick-panel).
- For vehicles with separately fused LEFT and RIGHT side parking light circuits, either 2 diodes (6-10 amps each)
or 2 external relays can be used to separate t


The H2-2 Parking Light input, can that be an Accessory input? Or does it have to be a constant 12V? I am confused on that.

Thanks
-Roger

I posted a TECH Sheet in this reply

There is a + parking light tap and a (-) tap
You need to decide WHICH one to use, the INPUT will be the one you decide, + or - and fuse it if you are using +
I would go with + as I put a picture of where the wires are

It has to a CONSTANT 12 volt source, since it flashes the lights BEFORE the car starts. And it needs power to do that. Any more questions, post.

[autotoys]

The replies in this THREAD is PUBLIC, but the thread was responded to because the poster is a CUSTOMER OF OURS and bought the product from us. It should have been posted in the customer's area. We mainly only respond to technical and tech sheet request for OUR CUSTOMERS ONLY. Please make sure all of your purchases are from AUTOTOYS.COM to receive proper technical support for your products.